Mistake in the instructions - Magnaflow Overland Series Catback Exhaust for Land Cruiser 250

TRD JON · 2025-07-03T02:13:36+00:00

Toyota’s revealed the Land Cruiser Commercial, and it’s a no-nonsense beast for the off-road purist. Rear seats? Gone. Side windows? Replaced with steel. What you get is all function, no fluff. ✅ 2.8L turbodiesel with up to 500 Nm of torque ✅ Full-time 4WD with low-range and locking center diff ✅ Up to 7,500 lbs towing capacity – bring the trailer, the toys, or the whole camp ✅ Payload up to 1,665 lbs and over 2,200 liters of flat cargo space (LWB) ✅ Ground clearance, 31° approach angle, and 700mm wading depth – it’s built to crawl This is the Cruiser reimagined for the trailhead, the job site, and the long haul to nowhere. Who else would daily this into the wilderness? Full cargo area with middle seat delete Still gets leather...

@Kai__Larsen

Member

Mar 26, 2025

I just installed my Magnaflow Overland Series Exhaust on the 250. And during installation noticed that part of the instructions are wrong. Magnaflow says you need a 13mm Socket. But no factory bolt or any of the hose/exhaust clamps from Magnaflow are a 13mm size. Instead you need a 14mm for the factory bolts and a 15mm for the exhaust clamps. (See pictures below)View attachment IMG_0787 copy.jpg
(Instructions showing 13mm requirement)

(14mm socket on the factory bolts to attach the inlet pipe)

(15mm to tighten the exhaust hose clamps)

I'll be emailing Magnaflow to address the issue. But wanted to put a forum post out in the event people have started ordering them. Obviously it's still not a big issue as I'm assuming if you have a 13mm socket you'll also have a 14 & 15mm. And they can easily change the instructions.

Anybody else run into this issue or just me? I know they just started shipping these.

You must log in or register to reply here.