Rago Fabrication Exterior Window MOLLE Panels for 250 Land Cruiser

@Kai__Larsen · 2025-04-03T16:16:36+00:00

In case anyone is wondering what their air intake in the LC250 looks like. I recently removed all my fender lines and exposed it. It's a much more different design than on my 5G 4Runner. This intake is longer and seems to have a small filtering system on the bottom. Now I need to figure out a DIY solution to cover it back up after I trim my fenders as the liners won't go back on how Toyota made them too. And unfortunately to my knowledge nobody in the US makes a snorkel for the LC250 yet. Although I have thought about trying to get one imported from AUS. Anyone imported a snorkel yet?

BG

Administrator

Staff member

Nov 9, 2024

I was actually surprised at how many exterior window molle panels were mounted on 250 Series Land Cruisers this year at SEMA. Prinsu had one of theirs mounted on a 250 in the Toyota booth and a few others were spotted on other builds. The Rago Fabrication molle panel, however, fits the contours of the land cruiser a bit better in my opinion. This one was mounted on the Doetsch Off-Road 250 for the Race Against Blindness Charity giveaway. I've never been a huge fan of these molle panels, but this one looks good. Especially paired with the new Rago Fab roof rack. This setup was pretty dialed.

Here is another look at panel from the side: