Rago Fabrication Exterior Window MOLLE Panels for 250 Land Cruiser

TRD JON · 2025-07-03T02:13:36+00:00

Toyota’s revealed the Land Cruiser Commercial, and it’s a no-nonsense beast for the off-road purist. Rear seats? Gone. Side windows? Replaced with steel. What you get is all function, no fluff. ✅ 2.8L turbodiesel with up to 500 Nm of torque ✅ Full-time 4WD with low-range and locking center diff ✅ Up to 7,500 lbs towing capacity – bring the trailer, the toys, or the whole camp ✅ Payload up to 1,665 lbs and over 2,200 liters of flat cargo space (LWB) ✅ Ground clearance, 31° approach angle, and 700mm wading depth – it’s built to crawl This is the Cruiser reimagined for the trailhead, the job site, and the long haul to nowhere. Who else would daily this into the wilderness? Full cargo area with middle seat delete Still gets leather...

BG

Administrator

Staff member

Nov 9, 2024

I was actually surprised at how many exterior window molle panels were mounted on 250 Series Land Cruisers this year at SEMA. Prinsu had one of theirs mounted on a 250 in the Toyota booth and a few others were spotted on other builds. The Rago Fabrication molle panel, however, fits the contours of the land cruiser a bit better in my opinion. This one was mounted on the Doetsch Off-Road 250 for the Race Against Blindness Charity giveaway. I've never been a huge fan of these molle panels, but this one looks good. Especially paired with the new Rago Fab roof rack. This setup was pretty dialed.

Here is another look at panel from the side: